Foil up the rest of the board that doesn’t require heating, and use the ‘ruler’ to ‘lift’ the optical cables away from the board at the base. Make yourself a nice foil shield about the size of a ruler in both thickness and length. There are 4 chips to rework (Two larger and two smaller rectangular ones). For my fix I use a hot air rework station (Aoyue) and patience. The area that we need to rework is the BGA chips circled directly underneath the optical cables in this image. If you are careful, you can get the board out and you will end up with something like: DO NOT remove the fibre optic leads from the board. You will need to start at the top, and then go down to the bottom. If you do so much as turn ignition off after a mile or two, you will just get the BWM reboot logo loop with sometimes dodgy lines on screen and other weird effects.ĬCC may now show as ‘dead’, but if the original issue is as above – Then it can be fixed Issue: CCC starts for the first boot in the morning, and maybe one in the afternoon if it has been left long enough / is cold enough outside. It may fix other symptoms but will 100% fix the following issue. Note: The following must be your symptoms for this fix to work.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |